The TD-SCDMA measurement suite enables characterization of TD-SCDMA transceivers in accordance with the requirements of 3GPP TS 34.122. The measurement suite comprises an easy to use GUI for manual operation and two measurement libraries with APIs (applications programming interfaces) for use in various ADEs (application development environments) such as LabVIEW, LabWindows/CVI, Visual Basic, Visual C/ C++ and .NET.
The PSD757-1, PSD767-1 and PSD767-2 Interface Units are used with B757 and B767 aircraft that are equipped with Honeywell fuel systems. The interface unit is installed in place of the fuel quantity system processor and connected to a PSD60-2R AC Fuel System Tester
A high-performance signal generator with programmable modulation sources and LF output, wide modulation bandwidths, sweep capability and excellent accuracy.
Aeroflex's 9101 Hand-Held Spectrum Analyzer is a low cost, full-featured spectrum analyzer. With a frequency range up to 4 GHz, the 9101 can test all modern wireless local oscillators, plus the harmonics and spurs that can mix and break through into the pass-band. Its complete coverage of carrier and IF stages give the performance needed when other analyzers run out of bandwidth.
he EAST500 is a single integrated LTE test system based upon proven test solutions: Aeroflex’s LTE RF air interface technology integrated with NetHawk’s load test capability. Both companies are leaders in LTE test.
TYPE 9721-A
Designed for calibration of working standard microphones and other types of microphone.
A secondary level microphone calibration system for calibration of working standard microphones and other types of microphone. The system, Type 9721-A, applies the comparison method for sensitivity calibration and the electrostatic actuator method for frequency response calibration.
Type 9721-A is a general-purpose microphone calibration system for calibration of working standard microphones described in IEC 61094-4, laboratory standard microphones described in IEC 61094-1 and other non-standard microphones. The system is intended for calibration service centres and owners of large amounts of microphones. The sensitivity of the microphone is measured by the pressure comparison method described in IEC 61094-5 and the frequency response is measured by the electrostatic actuator method described in IEC 61094-6.
What is TeraVM?