The SVA converts RF signals into digital IF or I&Q sampled data providing vector signal analysis of RF signals with functionality and performance required in the laboratory or the manufacturing test system.

Aeroflex's 9101 Hand-Held Spectrum Analyzer is a low cost, full-featured spectrum analyzer. With a frequency range up to 4 GHz, the 9101 can test all modern wireless local oscillators, plus the harmonics and spurs that can mix and break through into the pass-band. Its complete coverage of carrier and IF stages give the performance needed when other analyzers run out of bandwidth.

Aeroflex's 9102 Hand-Held Spectrum Analyzer is a multifunction instrument designed for lab and field applications concerning scalar network and spectrum analysis, including cable and antenna measurements and EMC pre-qualification tests.

Aeroflex's 9103 Hand-Held Spectrum Analyzer is a multifunction instrument designed for lab and field applications concerning scalar network and spectrum analysis, including cable and antenna measurements and EMC pre-qualification tests

Unparalleled speed, accuracy and dynamic range.

• Automated Intermodulation measurement on amplifiers and frequency converters
• Accurate spurious measurement on transmitters
• RF attenuator calibration and switch repeatability testing

Setting new standards in TETRA transmitter analysis where speed and accuracy counts.

• Accurate TETRA transmitter measurements
• Test TETRA base stations, terminals and direct mode radios
• All measurements made in accordance with ETSI EN 300 394-1

The 3030 Series of RF Digitizers used with a 3010 Series synthesizer module provide precision conversion of RF signals into digital IF or I and Q data.

The 3250 Series is probably the only RF analyzer you will need to design, analyze, test and check compliance in today’s complex RF and EMI environments.

This measurement system, based around the IFR 6800A series RF & Microwave Scalar and System Analyzers and the 6813A microwave generator, is designed to provide selective measurements of mixers and frequency converters during alignment and testing. The 6813 acts as the local oscillator input for the mixer under test while the 6840A series unit provides both the mixer RF input and the receiver for the IF output port.

The CS9000 and low-cost BSAs monitor, record, and analyze RF signals and signal environments. The RF signal is down converted to baseband and digitized into very deep RAM of up to 32 GB. The data in RAM can be stored to disk or RAID for later analysis or playback with an Aeroflex BroadBand Signal Generator.